Avid Technology Stage 48 Specifications download pdf (Page 15)

Stage 4810

3 Connect the included IEC power cable(s) between the Power

connector(s) on any Stage 48 units present and your power

source.

4 Press the Power switch on the first Stage 48 to power on the

device. The Status LED indicator is lit solid yellow while the

Stage 48 initializes.

5 If applicable, for the second Stage 48 connect power and

power on the device.

6 Wait for the Stage 48(s) to initialize. Initialization is com-

plete when the Power and Status LEDs on the Stage 48 front

panel are lit solid green.

7 Power on SC48 and wait for the Ethernet Snake card to ini-

tialize, indicated by a lit green Status LED. Audio will not pass

until the SC48 is fully initialized.

8 Both the Act and Sig LEDs on Stage 48 (s) and the Ethernet

Snake card in SC48 should be lit for all connected Ethernet

snakes.

9 You should now confirm your I/O in VENUE.

Confirming I/O

After making snake connections and powering up your sys-

tem, you can confirm your system’s available Stage I/O.

To confirm I/O in your system:

1 Go to Options > Devices to view your system hardware status.

The newly installed hardware should be displayed. All local

and remote Stage I/O appears in the SC48 Stage I/O slots in the

graphic.

2 Go to the Patchbay page and click the Stage tab to verify that

the inputs and/or outputs are available in the Patchbay.

A flashing red Power LED indicates a potential power prob-

lem. Power down, unplug Stage 48, and verify the power

source. See “Recessed Pushbutton” on page 6 for informa-

tion on LED indicator codes.

If the Sig LED does not light after you have connected a

Stage 48, make sure the ID switches on all connected

Stage 48 units are set properly.

Detail of Options > Devices page showing installed I/O

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 28 29

No comments

Avid Technology Stage 48 Specifications Page 15