Avid Technology Stage 48 Specifications download pdf (Page 19)

Stage 4814

5 To lock the Top Panel in the vertical position, tighten the two

interior captive thumbscrews located on the top left and top

right sides of the console.

6 Locate the card in slot D and loosen the two interior captive

thumbscrews that secure the card to the console chassis.

7 Disconnect the 50-pin ribbon cable by pushing the retaining

clips outwards.

8 On the back of the console, remove the four screws that se-

cure the card to the console chassis.

9 Gently slide the card out of the slot. If necessary, use a

flat-edged tool to pry the card away from the chassis.

10 If required, repeat to remove the card from slot E.

11 If you are finished removing cards, do the following to close

and secure the Top Panel:

• Loosen the captive thumbscrews and carefully lower the

Top Panel into position.

• Replace the screws that secure the Top Panel to the con-

sole chassis.

Figure 11. Tightening the top left captive thumbscrew

Figure 12. Loosening the captive thumbscrews

Figure 13. Disconnecting the 50-pin ribbon cable

Leave the disconnected ribbon cable in the console. Do not

attempt to remove it. Tuck the unconnected end of the cable

and any excess cabling in the gap along the inner right side

of the console.

Do not pry the card from the top. Doing so can damage the

copper strips located along the top of the card.

Figure 14. Removing the card from the slot

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 28 29

No comments

Avid Technology Stage 48 Specifications Page 19