Avid Technology Stage 48 Specifications download pdf (Page 18)

Chapter 4: Configuring and Installing I/O in Stage 48 13

8 Mark the cable end “A.” This will allow the cable to be easily

identified when the Ethernet Snake card is installed.

9 Loosen the two interior captive thumbscrews that secure the

card to the console chassis.

10 On the back of the console, remove the four screws that se-

cure the card to the console chassis.

11 Gently slide the card out of the slot. If necessary, use a

flat-edged tool to pry the card away from the chassis.

12 Repeat the procedure to remove the card from slot B of the

console. Mark the cable end “B.”

13 If required, repeat to remove the card from slot C. Mark the

cable end “C.”

14 If you are finished removing cards, do the following to close

and secure the Top Panel:

• Loosen the captive thumbscrews and carefully lower the

Top Panel into position.

• Replace the screws that secure the Top Panel to the con-

sole chassis.

Removing an Output Card

Output cards can be removed from SC48 and installed in

Stage 48. The following procedure shows how to remove an

output card from slot D of SC48.

To remove an AO16 card:

1 Shut down your system, and turn off power to SC48.

2 Disconnect any power cables from SC48, as well as any other

audio cables and peripherals attached to the console.

3 Remove the 26 screws that secure the Top Panel to the con-

sole chassis.

4 Hold the front edge of the Top Panel and carefully lift it up-

wards to a vertical position.

Figure 6. Loosening the captive thumbscrews

Do not pry the card from the top. Doing so can damage the

copper strips located along the top of the card.

Figure 7. Removing the card from the slot

Figure 8. Removing the 26 Top Panel screws

If you sense any resistance when lifting the Top Panel up-

wards, do not force it. The Top Panel has slots that pivot on

posts attached to the sides of the console chassis

(Figure 10). Removing the Top Panel screws may cause the

Top Panel to slide towards the front of the console so that

the Top Panel slots are not correctly aligned with the posts.

If this occurs, slide or push the Top Panel towards the rear

of the console before lifting, making sure the posts are cor-

rectly aligned with the slots.

Figure 9. Lifting the Top Panel to vertical

Figure 10. Correct alignment of Top Panel slot and pivot post

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 28 29

Comments to this Manuals

No comments

Avid Technology Stage 48 Specifications Page 18

Comments to this Manuals

Related products and manuals for Dimmers Avid Technology Stage 48